Recovery and going back

Get the pedal back after a failed flash, and return to Valeton’s firmware.

If a flash fails or the pedal doesn’t start

The pedal’s factory loader can’t be overwritten over USB, so this almost always works:

  1. Unplug the pedal.
  2. Hold the foot switch and press the PARA knob in, and keep both held while you plug the pedal back in. The screen stays dark: the pedal is in update mode.
  3. Flash again, with any of the usual ways: the firmware you had, another one, or Valeton’s.

Launchpad and the web flasher both see a pedal in update mode and offer to flash it.

When USB isn’t enough

In rare cases a pedal can’t be recovered over USB. Getting it back then needs an FT232H USB adapter wired to the pedal’s internal debug pads, which takes some soldering experience. Ask in the issues first; someone may be able to help.

Going back to Valeton’s firmware

You can return to Valeton’s firmware at any time.

  • With Launchpad: on the Flash page, choose Valeton’s firmware. Launchpad downloads version V1.0.6 from Valeton’s own site, checks it, and flashes it.

  • From the command line: download the GP-5 update from Valeton, unzip it, and flash all of it:

    python3 tools/gp5tool.py flash GP-5_USB_V1.0.6_20250626.bin --sections all
    

Valeton’s own updater, Valeton Suite, is not a reliable way back. Use one of the ways above.

Valeton’s firmware starts with its factory presets. If you backed up your presets before leaving it, restore them on Launchpad’s Backups page.